Model |
SR-601 |
OPEN SIZE |
47X35X29.5cm |
N.W. |
8.0kgs |
G.W. |
18kgs |
Packing |
2PCS/CTN |
·Loosen the four spacing knobs enough to allow the wood stock to move easily through the openings.
·Tighten the spacing knobs until the wood stock is held in place(DO not over torque the spacing knobs).
·Using the Eccentric Bars adjust the wood stock to the proper pLacement and tighten by pushing them into a locked position.(The vertical baR pushes down.The horizontal pushes back).
·The vertical wood stock must be Offser to the horizontal wood stock by the width of one comb on the comb table.The top edges of the two pieces must remain flush.
·If necessary.adjust the forward/backward position of the comb table until the tips of the combs are approximately 5/32"clear of the vertical wood stock do this loosen the Comb Table adjusting knobs,move the inward or outward until the position is achieved,then tighten the Knobs again.
|